Home › Vehicle Interior › ENGINE IMMOBILISER › TRANSPONDER KEY ECU
RM27M0U _58 Vehicle Interior _049156 ENGINE IMMOBILISER _0234434 TRANSPONDER KEY ECU A

ENGINE IMMOBILISER  TRANSPONDER KEY ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE AIR CONDITIONING UNIT

Hide 89780 4.REMOVE TRANSPONDER KEY ECU

a.
B356576

Disconnect the lower part of the transponder key ECU, and then disconnect the upper part to remove the transponder key ECU as shown in the illustration.