The combination meter receives engine speed signals from the ECM via the CAN line. The combination meter displays engine speed data that is calculated based on the data received from the ECM.
Check if a CAN communication system DTC is output (See page Power Source / Network>CAN COMMUNICATION>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
A
B
Operate the Techstream according to the display and select "Active Test" (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Tachometer Operation | Tachometer | 0, 1000, 2000, 3000, 4000, 5000, 6000, 7000 | - |
Needle indication is normal.
Confirm that the vehicle is stopped and engine idling.
OK
NG
Operate the Techstream according to the display and select "Active Test" (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Engine Rpm | Engine speed/Min.: 0, Max.: 12750 | Idling: 700 to 800 | Unit: rpm |
Engine speed displayed on Techstream is almost the same as actual engine speed.
OK
NG
Operate the Techstream according to the display and select "Data List" (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DATA LIST / ACTIVE TEST).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Engine Speed | Engine speed/Min.: 0, Max.: 16838.75 | Idling: 700 to 800 | Unit: rpm |
Engine speed displayed on Techstream is almost the same as actual engine speed.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (for 1UR-FE) | B |
| NG (for 3UR-FE) | C |
| NG (for 3UR-FBE) | D |
A
B
C
D