Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234441 INTUITIVE PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTUITIVE PARKING ASSIST SYSTEM  Front Clearance Sonar Sensor LH Circuit  


DESCRIPTION

The No. 1 ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.

WIRING DIAGRAM

E270572E25
4.156,2.094 5.729,2.49 1.573,0.396 10 false No. 1 Ultrasonic Sensor (Front Corner Sensor LH) 4.146,1.927 4.458,2.125 0.313,0.198 10 false C1 4.219,0.552 4.375,0.75 0.156,0.198 10 false 1 4.229,0.938 4.385,1.135 0.156,0.198 10 false 3 4.219,1.313 4.375,1.51 0.156,0.198 10 false 5 4.406,0.667 4.719,0.865 0.313,0.198 10 false BI 4.406,1.042 4.719,1.24 0.313,0.198 10 false SI 4.406,1.406 4.719,1.604 0.313,0.198 10 false EI 2.833,0.958 2.99,1.156 0.156,0.198 10 false 4 2.833,0.563 2.99,0.76 0.156,0.198 10 false 2 2.833,1.313 2.99,1.51 0.156,0.198 10 false 6 2.531,0.677 2.844,0.875 0.313,0.198 10 false BO 2.531,1.052 2.844,1.25 0.313,0.198 10 false SO 2.542,1.406 2.854,1.604 0.313,0.198 10 false EO 1.594,1.885 1.906,2.083 0.313,0.198 10 false B1 1.594,2.073 3.156,2.448 1.563,0.375 10 false No. 1 Ultrasonic Sensor (Front Corner Sensor RH)

PROCEDURE

1.REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)
a.

Remove the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL).


b.

Inspect the No. 1 ultrasonic sensor (front corner sensor LH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>INSPECTION)



OK

2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CORNER SENSOR RH)

NG

REPLACE NO. 1 ULTRASONIC SENSOR (FRONT CORNER SENSOR LH)

2.CHECK HARNESS AND CONNECTOR (FRONT CORNER SENSOR LH - FRONT CORNER SENSOR RH)
a.

Disconnect the C1 No. 1 ultrasonic sensor (front corner sensor LH) connector.


b.

Disconnect the B1 No. 1 ultrasonic sensor (front corner sensor RH) connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
C1-1 (BI) - B1-2 (BO) Always Below 1 Ω
C1-3 (SI) - B1-4 (SO) Always Below 1 Ω
C1-5 (EI) - B1-6 (EO) Always Below 1 Ω
C1-1 (BI) - Body ground Always 10 kΩ or higher
C1-3 (SI) - Body ground Always 10 kΩ or higher
C1-5 (EI) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR