53101
1.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
for Standard:
(See page Vehicle Interior>EXTERIOR>RADIATOR GRILLE>REMOVAL)
w/ Off Road Package:
(See page Vehicle Interior>EXTERIOR>RADIATOR GRILLE(w/ Off Road Package)>REMOVAL)
53932B
2.REMOVE FRONT END PANEL LH
53931B
3.REMOVE FRONT END PANEL RH
52521
4.REMOVE FRONT BUMPER CENTER UPPER RETAINER
5.REMOVE FRONT BUMPER COVER
89348
6.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (for Steel Type Bumper)
Remove the No. 1 ultrasonic sensor retainer as shown in the illustration.
The illustration shows the No. 1 ultrasonic sensor retainer for the LH. The horizontal orientation of the No. 1 ultrasonic sensor retainer for the RH is opposite that of the image shown in the illustration.
89341A
7.REMOVE NO. 1 ULTRASONIC SENSOR (for Steel Type Bumper)
Remove the No. 1 ultrasonic sensor as shown in the illustration.
The illustration shows the No. 1 ultrasonic sensor for the LH. The horizontal orientation of the No. 1 ultrasonic sensor for the RH is opposite that of the image shown in the illustration.
89341A
8.REMOVE NO. 1 ULTRASONIC SENSOR (for Resin Type Bumper)
Detach the 4 claws and remove the No. 1 ultrasonic sensor as shown in the illustration.
The illustration shows the No. 1 ultrasonic sensor for the RH. The horizontal orientation of the No. 1 ultrasonic sensor for the LH is opposite that of the image shown in the illustration.