PARK ASSIST / MONITORING
INTUITIVE PARKING ASSIST SYSTEM
REAR VIEW MONITOR SYSTEM(for Radio and Display Type)
REAR VIEW MONITOR SYSTEM(for Navigation Receiver Type)
BLIND SPOT MONITOR SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- OPERATION CHECK2015.08–2016.08from 2016.08
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART2015.08–2016.08from 2016.08
- U0100, U0126, U0129, U0142
- U0232 The blind spot monitor sensor RH cannot receive signals from the blind spot monitor sensor LH.
- U1331 Destination information of the main body ECU (driver side junction block assembly) and blind spot monitor...
- C1AC2 When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is...2015.08–2016.08from 2016.08
- C1AC1 When the blind spot monitor sensor deviates 5 degrees or more from the horizontal axis when the system is...2015.08–2016.08from 2016.08
- C1ABD, C1ABE
- C1ABC A beam axis inspection has not been performed.
- C1ABB A beam axis inspection has not been performed.
- C1AB8 The blind spot monitor sensor cannot communicate with the main body ECU (driver side junction block assembly).
- C1AB7 The blind spot monitor sensor LH (slave) detects an internal malfunction.
- C1AB6 The blind spot monitor sensor RH (master) detects an internal malfunction.
- C1AB5 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the current flowing...
- C1AB4 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the current flowing...
- C1AB3 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output...
- C1AB2 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage output...
- C1AB1 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage applied...
- C1AB0 With the blind spot monitor main switch assembly (warning canceling switch assembly) on, the voltage applied...
- C1A45 A fail flag is transmitted from the skid control ECU (brake actuator assembly).
- C1A47 A fail flag is transmitted from the steering sensor
- Main Switch Circuit
- Power Source Circuit
CLEARANCE WARNING ECU
ULTRASONIC SENSOR(for Front Side)
ULTRASONIC SENSOR(for Rear Side)
TELEVISION CAMERA
CLEARANCE SONAR MAIN SWITCH
BLIND SPOT MONITOR SENSOR
BLIND SPOT MONITOR MAIN SWITCH
REAR CROSS TRAFFIC ALERT BUZZER(for Double Cab)
REAR CROSS TRAFFIC ALERT BUZZER(for CrewMax)
REAR CROSS TRAFFIC ALERT BUZZER(for Regular Cab)