The No. 1 ultrasonic sensor sends and receives ultrasonic waves. Based on the received wave, the sensor calculates the approximate distance value between the vehicle and the obstacle, and sends the distance value as a signal to the clearance warning ECU assembly.
Remove the No. 1 ultrasonic sensor (front corner sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>REMOVAL).
Inspect the No. 1 ultrasonic sensor (front corner sensor RH) (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>ULTRASONIC SENSOR(for Front Side)>INSPECTION).
OK
NG
Disconnect the B1 No. 1 ultrasonic sensor (front corner sensor RH) connector.
Disconnect the J35 clearance warning ECU assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B1-1 (BI) - J35-3 (BOF) | Always | Below 1 Ω |
| B1-3 (SI) - J35-5 (SOF) | Always | Below 1 Ω |
| B1-5 (EI) - J35-4 (E5) | Always | Below 1 Ω |
| B1-1 (BI) - Body ground | Always | 10 kΩ or higher |
| B1-3 (SI) - Body ground | Always | 10 kΩ or higher |
| B1-5 (EI) - Body ground | Always | 10 kΩ or higher |
OK
NG