The clearance warning buzzer is installed in the combination meter assembly.
Disconnect the J35 clearance warning ECU assembly connector.
Disconnect the J28 combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| J35-2 (ER) - J28-3 (BZ) | Always | Below 1 Ω |
| J35-2 (ER) - Body ground | Always | 10 kΩ or higher |
OK
NG
Replace the combination meter assembly with a normally functioning or new one (See page Vehicle Interior>METER / GAUGE / DISPLAY>COMBINATION METER>REMOVAL).
Check that the clearance warning buzzer operates normally.
Clearance warning buzzer operates normally.
OK
NG