89341A
1.INSTALL NO. 1 ULTRASONIC SENSOR (for Steel Type Bumper)
Install the No. 1 ultrasonic sensor as shown in the illustration.
Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor.
89348
2.INSTALL NO. 1 ULTRASONIC SENSOR RETAINER (for Steel Type Bumper)
Install the No. 1 ultrasonic sensor retainer as shown in the illustration.
89341A
3.INSTALL NO. 1 ULTRASONIC SENSOR (for Resin Type Bumper)
Attach the 4 claws to install the No. 1 ultrasonic sensor as shown in the illustration.
| *a | No. 1 ultrasonic sensor direction |
| *b | Keyhole direction |
No. 1 ultrasonic sensor direction is the same as the keyhole direction.
Do not damage the bumper with the protrusion when installing the No. 1 ultrasonic sensor.
4.INSTALL FRONT BUMPER COVER
52521
5.INSTALL FRONT BUMPER CENTER UPPER RETAINER
53932B
6.INSTALL FRONT END PANEL LH
53931B
7.INSTALL FRONT END PANEL RH
53101
8.INSTALL RADIATOR GRILLE SUB-ASSEMBLY
for Standard:
(See page Vehicle Interior>EXTERIOR>RADIATOR GRILLE>INSTALLATION)
w/ Off Road Package:
(See page Vehicle Interior>EXTERIOR>RADIATOR GRILLE(w/ Off Road Package)>INSTALLATION)
9.ADJUST FOG LIGHT