Avoid any impact to the blind spot monitor sensor.
Do not drop the blind spot monitor sensor. If it is dropped, replace it with a new one.
82821A
1.REMOVE CONNECTOR COVER (w/o Towing Package)
82824X
2.REMOVE WIRING HARNESS CONNECTOR (w/ Towing Package)
3.REMOVE REAR BUMPER COVER
52164A
4.REMOVE REAR BUMPER PLATE LH
52163A
5.REMOVE REAR BUMPER PLATE RH
52057
6.REMOVE REAR BUMPER PAD SUB-ASSEMBLY LH
81690A
7.REMOVE LICENCE PLATE LIGHT ASSEMBLY LH
81270D
8.REMOVE LICENSE PLATE LIGHT ASSEMBLY RH
Use the same procedure described for the LH side.
52156E
9.REMOVE REAR BUMPER EXTENSION INSERT LH
52155E
10.REMOVE REAR BUMPER EXTENSION INSERT RH
88172
11.REMOVE BLIND SPOT MONITOR SENSOR LH
Disconnect the connector.
Remove the 3 nuts and blind spot monitor sensor LH.
88162
12.REMOVE BLIND SPOT MONITOR SENSOR RH
Disconnect the connector.
Remove the 3 nuts and blind spot monitor sensor RH.