Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234450 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U0100  Lost Communication with ECM / PCM "A"  U0126  Lost Communication with Steering Angle Sensor Module  U0129  Lost Communication with Brake System Control Module  U0142  Lost Communication with Body Control Module "B"  


DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the blind spot monitor sensor.

HINT:

If CAN communication system DTCs are stored, they may also be stored for other systems.


DTC Code DTC Detection Condition Trouble Area
U0100 Lost communication with ECM CAN communication system
U0126 Lost communication with steering sensor
U0129 Lost communication with skid control ECU (brake actuator assembly)
U0142 Lost communication with main body ECU (driver side junction block assembly)

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK DTC

b.

Check for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).

Result
Result Proceed to
DTCs are output A
No DTCs are output B


HINT:
·

If CAN communication system DTCs are stored, they may also be stored for other systems.

·

If the CAN communication system has been inspected and repaired, the DTCs will not be output when rechecking for DTCs.

·

If these DTCs are output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR).




A

B