Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234450 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1A47  Steering Angle Sensor  


DESCRIPTION

The blind spot monitor sensor receives steering angle signals from the steering sensor via CAN communication.

DTC Code DTC Detection Condition Trouble Area
C1A47 A fail flag is transmitted from the steering sensor
·

Steering sensor

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

NG

2.REPLACE STEERING SENSOR
2.REPLACE STEERING SENSOR
a.

Replace the steering sensor with a new or normally functioning one (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL).



NEXT

3.CHECK DTC
3.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH (master) B
DTC is output from the blind spot monitor sensor LH (slave) C



A

END (STEERING SENSOR IS DEFECTIVE)

B

C