Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234450 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1ABB  Blind Spot Monitor Master Module Beam Axis Inspection Incomplete  


DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.


DTC Code DTC Detection Condition Trouble Area
C1ABB A beam axis inspection has not been performed. Blind spot monitor sensor RH

PROCEDURE

1.PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)
a.

Change the blind spot monitor sensor RH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>OPERATION CHECK).




NEXT

END