Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27M0U _56 Audio / Visual / Telematics _049159 PARK ASSIST / MONITORING _0234450 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  U1331  Software Incompatibility with Body Control Module "B"  


DESCRIPTION

This DTC is stored when the destination information of the main body ECU (driver side junction block assembly) does not match that of the blind spot monitor sensors.

DTC Code DTC Detection Condition Trouble Area
U1331 Destination information of the main body ECU (driver side junction block assembly) and blind spot monitor sensor do not match.
·

Main body ECU (driver side junction block assembly)

·

Blind spot monitor sensor LH

·

Blind spot monitor sensor RH



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CONFIRM PART NUMBER (MAIN BODY ECU [DRIVER SIDE JUNCTION BLOCK ASSEMBLY])
a.

Check the main body ECU (driver side junction block assembly) part number.

i.

Check if the part number of the main body ECU (driver side junction block assembly) installed on the vehicle is correct.

OK:

The part number is correct.





OK

2.CHECK DTC

NG

REPLACE MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK ASSEMBLY)

2.CHECK DTC

b.

Recheck for DTCs and check if the same DTC is output again.

Result
Result Proceed to
No DTC is output A
DTC is output from the blind spot monitor sensor RH (master) B
DTC is output from the blind spot monitor sensor LH (slave) C



A

B

C