Home › Vehicle Interior › SLIDING ROOF › SLIDING ROOF HOUSING(for CrewMax)
RM27M0U _58 Vehicle Interior _049166 SLIDING ROOF _0234507 SLIDING ROOF HOUSING(for CrewMax) A

SLIDING ROOF  SLIDING ROOF HOUSING(for CrewMax)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.


Hide 63310 3.REMOVE ROOF HEADLINING ASSEMBLY

a.

Hide 62180A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

Hide 62170A 5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

HINT:

Use the same procedures described for the LH side.


Hide 63218M 6.REMOVE SLIDING ROOF SIDE GARNISH LH

B231300

a.

Detach the 6 claws and remove the side garnish.


Hide 63217K 7.REMOVE SLIDING ROOF SIDE GARNISH RH

HINT:

Use the same procedures described for the LH side.


Hide 63201G 8.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY

B170246

a.

Using a T25 "TORX" driver, remove the 4 screws and glass.


Hide 63251H 9.REMOVE SLIDING ROOF WEATHERSTRIP

a.

Remove the sliding roof weatherstrip.


Hide 63203F 10.REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY

a.

Disconnect the 4 sliding roof drain hoses.


b.

Remove the 10 bolts, 6 nuts and housing.

B170247