Use these procedures to troubleshoot the tire pressure warning system.
*: Use the Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer to confirm the trouble.
It is important to collect as much specific information as possible from the customer to allow for a quick repair.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Data List.
Read the "ID Tire Inflation Pressure" values.
Adjust all tire pressures to the standard values.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>PRECAUTION
Check the Data List.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
It may take up about 5 to 6 minutes to display the updated tire pressure data.
If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.
| Result | Proceed to |
|---|---|
| Tire pressure warning light remains on. | A |
| Tire pressure warning light goes off. | B |
A
B
Check for DTC.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC is output | A |
| DTC is not output | B |
A
B
Refer to the Diagnostic Trouble Code Chart.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Problem Symptoms Table.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>PROBLEM SYMPTOMS TABLE
| Proceed to |
|---|
| NEXT |
NEXT
Refer to the Electronic Circuit Inspection Procedure.
| Proceed to |
|---|
| NEXT |
NEXT
Repair or replace parts based on the diagnosis result.
| Proceed to |
|---|
| NEXT |
NEXT
Check the Data List to confirm that the tire inflation pressure data has been received.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST
Perform initialization.
Click hereDrivetrain>TIRE AND WHEEL>TIRE PRESSURE WARNING SYSTEM>INITIALIZATION
Confirm that the initialization has been completed.
| Proceed to |
|---|
| NEXT |
NEXT