Use these procedures to troubleshoot the engine immobiliser system.
*: Use the Techstream.
| Proceed to |
|---|
| NEXT |
NEXT
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs and note any codes that are output.
Click hereVehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Clear the DTCs.
Click hereVehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs. Try to duplicate the DTC (SFI system and engine immobiliser system) by simulating the symptoms indicated by the DTC.
| Result | Proceed to |
|---|---|
| DTC is not output | A |
| SFI system (for 1UR-FE) DTC is output | B |
| SFI system (for 3UR-FE) DTC is output | C |
| SFI system (for 3UR-FBE) DTC is output | D |
| Engine immobiliser system DTC is output | E |
A
B
Click hereEngine / Hybrid System>1UR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
C
Click hereEngine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
D
Click hereEngine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
E
Click hereVehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DIAGNOSTIC TROUBLE CODE CHART
| Result | Proceed to |
|---|---|
| Fault is not listed in problem symptoms table | A |
| Fault is listed in problem symptoms table | B |
A
B
Data List/Active Test
Click hereVehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>DATA LIST / ACTIVE TEST
Terminals of ECU
Click hereVehicle Interior>ENGINE IMMOBILISER>ENGINE IMMOBILISER SYSTEM>TERMINALS OF ECU
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT