Home › Vehicle Interior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)
RM27M0U _58 Vehicle Interior _049161 WINDOW / GLASS _0234473 POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function) Y

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the power window control system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT BATTERY VOLTAGE
2.INSPECT BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the battery before proceeding.

Result:
Proceed to
NEXT



NEXT

3.CHECK FOR DTC*
3.CHECK FOR DTC*
a.

Check for DTCs and make a note of any codes that are output.


b.

Clear the DTCs.


c.

Recheck for DTCs. Based on the DTCs output in the first step, try to force output of the same DTC by simulating the detection conditions indicated by the DTC.


Result:
Result Proceed to
No DTCs output A
DTCs output B
CAN communication system DTCs are output C
LIN communication system DTCs are output D



A

4.PROBLEM SYMPTOMS TABLE

B

C

D

4.PROBLEM SYMPTOMS TABLE

Result:
Result Proceed to
Fault not listed in Problem Symptoms Table A
Fault listed in Problem Symptoms Table B



A

5.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

6.REPAIR OR REPLACEMENT
6.REPAIR OR REPLACEMENT
Result:
Result Proceed to
Door window regulator and power window regulator motor is replaced or removed/installed. A
Door window regulator and power window regulator motor is not replaced or removed/installed. B



A

7.RESET POWER WINDOW REGULATOR MOTOR

B

8.CONFIRMATION TEST
7.RESET POWER WINDOW REGULATOR MOTOR
a.

If the master switch AUTO light is blinking, reset the power window regulator motor.

Click hereVehicle Interior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM(w/ Jam Protection Function)>INITIALIZATION


Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END