Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly LH (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
11101A
1.INSPECT CYLINDER HEAD SET BOLT
11101
2.INSPECT CYLINDER HEAD SUB-ASSEMBLY LH
11116
3.INSTALL CYLINDER HEAD GASKET LH
Check the piston protrusions for each cylinder.
Clean the cylinder block with solvent.
Set the piston of the cylinder to be measured to slightly ATDC.
Place the cylinder head gasket on the cylinder block surface with the front face of the Lot No. stamp upward.
Be careful of the installation direction.
Make sure that no oil is on the front end (indicated by the arrows) of the cylinder head gasket.
11101
4.INSTALL CYLINDER HEAD SUB-ASSEMBLY LH
Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly LH (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
Place the cylinder head on the cylinder block.
Ensure that no oil is on the mounting surface of the cylinder head.
Gently place the cylinder head in order not to damage the gasket with the bottom part of the head.
The cylinder head bolts are tightened in 3 progressive steps.
Apply a light coat of engine oil to the threads and under the heads of the cylinder head bolts.
Step 1:
Using a 10 mm bi-hexagon wrench, install and uniformly tighten the 10 cylinder head bolts with the plate washers in several steps, in the sequence shown in the illustration.
Step 2:
Mark each cylinder head bolt head with paint as shown in the illustration.
Tighten the cylinder head bolts another 90° in the sequence shown in step 1.
Step 3:
Tighten the cylinder head bolts an additional 90° in the sequence shown in step 1.
Check that the painted marks are now facing rearward.
Install and uniformly tighten the 2 bolts in the sequence shown in the illustration.
13716
5.INSTALL VALVE STEM CAP
Apply a light coat of engine oil to the valve stem caps.
Install the 16 valve stem caps to the cylinder head.
13750
6.INSTALL VALVE LASH ADJUSTER ASSEMBLY
Inspect the valve lash adjuster (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>ENGINE UNIT>INSPECTION).
Install the 16 valve lash adjusters to the cylinder head.
Install the lash adjuster at the same place it was removed from.
13801
7.INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY
Apply engine oil to the lash adjuster tips and valve stem cap ends.
Install the 16 valve rocker arms as shown in the illustration.
8.INSTALL CAMSHAFTS (for Bank 1)
Install the camshafts (See page Engine / Hybrid System>3UR-FBE ENGINE MECHANICAL>CAMSHAFT(for Bank 1)>INSTALLATION).
17105
9.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
Install the exhaust manifold LH (See page Engine / Hybrid System>3UR-FBE EXHAUST>EXHAUST MANIFOLD>INSTALLATION).