17104
1.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
Install a new gasket to the cylinder head and a new gasket to the No. 2 air tube.
Install the exhaust manifold gasket with the gasket tab facing toward the front of the engine.
Install the air tube gasket with the gasket's claws facing the tube side.
Temporarily install the exhaust manifold with the 2 nuts labeled A and 8 new nuts.
Uniformly tighten the nuts that are not labeled A, and then tighten the 2 nuts labeled A.
17167
2.INSTALL NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
Install the heat insulator with the 3 bolts.
17105
3.INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
Install a new gasket to the cylinder head and a new gasket to the No. 3 air tube.
Install the exhaust manifold gasket with the gasket tab facing toward the rear of the engine.
Install the air tube gasket with the gasket's claws facing the tube side.
Temporarily install the exhaust manifold with the 2 nuts labeled A and 8 new nuts.
Uniformly tighten the nuts that are not labeled A, and then tighten the 2 nuts labeled A.
17168
4.INSTALL NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Install the heat insulator with the 3 bolts.
45203
5.INSTALL NO. 2 STEERING INTERMEDIATE SHAFT SUB-ASSEMBLY
Align the matchmarks and insert the No. 2 intermediate shaft into the intermediate shaft.
Align the matchmarks and insert the No. 2 intermediate shaft into the power steering gear.
Install the 2 bolts.
17410
6.INSTALL FRONT EXHAUST PIPE ASSEMBLY
37140
7.INSTALL FRONT PROPELLER SHAFT ASSEMBLY (for 4WD)
88320
8.CONNECT COOLER COMPRESSOR ASSEMBLY
27020
9.INSTALL GENERATOR ASSEMBLY
44320
10.CONNECT VANE PUMP ASSEMBLY
11452
11.INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE
16711
12.INSTALL FAN SHROUD
16361A
13.INSTALL FAN AND GENERATOR V-BELT
16572
14.CONNECT OUTLET RADIATOR HOSE
16571
15.CONNECT INLET RADIATOR HOSE
16.INSTALL AIR CLEANER ASSEMBLY
17880
17.INSTALL AIR CLEANER HOSE ASSEMBLY
18.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
19.ADD ENGINE COOLANT
20.INSPECT FOR COOLANT LEAK
21.INSPECT FOR EXHAUST GAS LEAK
If gas is leaking, tighten the areas necessary to stop the leak. Replace damaged parts as necessary.
If an exhaust gas leak has been repaired, perform an inspection following the repair (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION).
53739A
22.INSTALL FRONT FENDER APRON SEAL REAR LH
Install the fender apron seal with the 5 clips.
53737B
23.INSTALL FRONT FENDER APRON SEAL LH
Install the fender apron seal with the 6 clips.
53736A
24.INSTALL FRONT FENDER APRON SEAL REAR RH
Install the fender apron seal with the 5 clips.
53736
25.INSTALL FRONT FENDER APRON SEAL RH
Install the fender apron seal with the 6 clips.
51441
26.INSTALL NO. 1 ENGINE UNDER COVER
11209
27.INSTALL V-BANK COVER SUB-ASSEMBLY