Home › Vehicle Interior › METER / GAUGE / DISPLAY › METER / GAUGE SYSTEM
RM3700E _58 Vehicle Interior _093087 METER / GAUGE / DISPLAY _0438738 METER / GAUGE SYSTEM J

METER / GAUGE / DISPLAY  METER / GAUGE SYSTEM  Steering Pad Switch Circuit  


DESCRIPTION

The combination meter assembly and steering pad switch assembly are connected via direct line. The multi-information display in the combination meter assembly are operated using the switches of the steering pad switch assembly.

WIRING DIAGRAM

E409488E08
0.854,4.125 2.938,4.531 2.083,0.406 10 false Steering Pad Switch Assembly 3.531,4.125 5.594,4.677 2.063,0.552 10 false Spiral Cable Sub-assembly 5.719,2.531 6.938,2.979 1.219,0.448 10 false H6 5.719,2.698 7,3.292 1.281,0.594 10 false Combination Meter Assembly 5.479,1.844 6.031,2.094 0.552,0.25 10 false 32 5.76,1.865 6.313,2.115 0.552,0.25 10 false MSM+ 5.771,0.885 6.323,1.135 0.552,0.25 10 false MSTI 5.49,0.875 6.042,1.125 0.552,0.25 10 false 15 6.698,0.76 7.063,1.021 0.365,0.26 10 false 5 V 6.708,1.76 7.073,2.021 0.365,0.26 10 false 5 V 4.417,0.979 4.781,1.24 0.365,0.26 10 false H60 3.479,0.99 3.844,1.25 0.365,0.26 10 false z2 3.458,3.313 3.823,3.573 0.365,0.26 10 false 10 3.51,1.802 3.875,2.063 0.365,0.26 10 false 4 3.521,0.792 3.885,1.052 0.365,0.26 10 false 5 4.469,0.802 4.833,1.063 0.365,0.26 10 false 10 4.469,1.792 4.833,2.052 0.365,0.26 10 false 11 4.5,3.302 4.865,3.563 0.365,0.26 10 false 4 2.396,3.146 2.823,3.406 0.427,0.26 10 false Back 2.396,2.656 2.823,2.917 0.427,0.26 10 false Enter 0.917,1.646 1.344,1.906 0.427,0.26 10 false Left 0.885,3.167 1.313,3.427 0.427,0.26 10 false Right 0.875,2.625 1.302,2.885 0.427,0.26 10 false Down 0.948,2.167 1.375,2.427 0.427,0.26 10 false Up 4.021,1.875 4.448,2.135 0.427,0.26 10 false +DP 3.938,0.865 4.365,1.125 0.427,0.26 10 false +DP2 4.01,3.396 4.438,3.656 0.427,0.26 10 false EAU 2.958,0.875 3.385,1.135 0.427,0.26 10 false +DP2 3.042,1.833 3.469,2.094 0.427,0.26 10 false +DP 3.021,3.365 3.448,3.625 0.427,0.26 10 false EAU 4.438,1.969 4.802,2.229 0.365,0.26 10 false H60 4.427,3.479 4.792,3.74 0.365,0.26 10 false H60 3.479,1.969 3.844,2.229 0.365,0.26 10 false z2 3.469,3.479 3.833,3.74 0.365,0.26 10 false z2

CAUTION / NOTICE / HINT

NOTICE:

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.


PROCEDURE

1.INSPECT STEERING PAD SWITCH ASSEMBLY

Click hereSteering>STEERING COLUMN>STEERING PAD SWITCH>INSPECTION

Result:
Proceed to
OK
NG



OK

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

NG

REPLACE STEERING PAD SWITCH ASSEMBLY

2.INSPECT SPIRAL CABLE SUB-ASSEMBLY

OK

3.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)

NG

REPLACE SPIRAL CABLE SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (SPIRAL CABLE SUB-ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the H60 spiral cable sub-assembly connector.


b.

Disconnect the H6 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

Click Location & Routing(H60,H6)Location & Routing

Click Connector(H60)Instrument Panel>Instrument Panel Wire / Speaker Wire>Spiral Cable Sub-Assembly

Click Connector(H6)Instrument Panel>Instrument Panel Wire / Speaker Wire>Combination Meter Assembly

H60-10 (+DP2) - H6-15 (MSTI) Always Below 1 Ω
H60-11 (+DP) -H6-32 (MSM+) Always Below 1 Ω
H60-4 (EAU) - Body ground Always Below 1 Ω
H60-10 (+DP2) or H6-15 (MSTI) - Body ground Always 10 kΩ or higher
H60-11 (+DP) or H6-32 (MSM+) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE COMBINATION METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR