| *1 | CANISTER (FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY) | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during canister (fuel suction plate sub-assembly) removal/installation are shown below.
After the ignition switch is turned off, the radio and display receiver assembly records various types of memory and settings. As a result, after turning the ignition switch off, make sure to wait at least 120 seconds before disconnecting the cable from the negative (-) auxiliary battery terminal.
When the cable is disconnected / reconnected to the battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
77020A
1.REMOVE FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
3.REMOVE SUB-ASSEMBLY SUPPORT
77785
4.REMOVE FUEL PUMP HARNESS
5.REMOVE NO. 1 CAP
23210A
6.REMOVE FUEL PUMP ASSEMBLY WITH MOTOR AND BRACKET
7.REMOVE NO. 2 FUEL SUCTION SUPPORT
23070
8.REMOVE FUEL MAIN VALVE ASSEMBLY