|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458H
1.INSTALL NO. 2 FUEL PRESSURE SENSOR
|
|
Apply gasoline to a new O-ring.
Install the O-ring to the No. 2 fuel pressure sensor.
Install the No. 2 fuel pressure sensor to the fuel delivery pipe sub-assembly.
23851A
2.INSTALL NO. 2 FUEL PRESSURE SENSOR HOLDER
Using an 8 mm socket wrench, install the No. 2 fuel pressure sensor holder to the fuel delivery pipe sub-assembly with the bolt.
Connect the No. 2 fuel pressure sensor connector.
17881
3.INSTALL NO. 1 AIR CLEANER HOSE
12262
4.INSTALL NO. 2 VENTILATION HOSE
5.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
6.INSPECT FOR FUEL LEAK
7. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
8.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the No. 2 fuel pressure sensor.
Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION