| *A | Type A | *B | Type B |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during camshaft removal/installation are shown below.
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
11320B
1.REMOVE NO. 2 TIMING CHAIN COVER ASSEMBLY
13519
2.REMOVE OIL PUMP DRIVE GEAR
13506
5.REMOVE CHAIN SUB-ASSEMBLY
13521
6.REMOVE CRANKSHAFT TIMING GEAR OR SPROCKET
13559
8.REMOVE CHAIN TENSIONER SLIPPER
13561
9.REMOVE NO. 1 CHAIN VIBRATION DAMPER
13631
12.REMOVE BALANCESHAFT DRIVE GEAR
13501A
17.REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY
13502B
18.REMOVE EXHAUST CAMSHAFT SUB-ASSEMBLY