| ● | Non-reusable part | - | - |
| Procedure | Part NameCode |
|
|
|
|
|---|---|---|---|---|---|
| 11 | NO. 4 WATER BY-PASS HOSE | 16281 | - | - | - |
| 12 | NO. 2 VENTILATION HOSE | 12262 | - | - | - |
| 13 | WIRE HARNESS CLAMP BRACKET | - | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.
82219C
7.REMOVE SENSOR WIRE
Disengage the clamp.
Remove the bolt and sensor wire from the water inlet with thermostat sub-assembly.
11452D
9.REMOVE OIL LEVEL GAGE GUIDE
Using an 8 mm socket wrench, remove the bolt and engine oil level dipstick guide from the cylinder head sub-assembly.
Remove the O-ring from the engine oil level dipstick guide.
10.REMOVE WATER BY-PASS PIPE ASSEMBLY
16281
11.REMOVE NO. 4 WATER BY-PASS HOSE
12262
12.REMOVE NO. 2 VENTILATION HOSE
13.REMOVE WIRE HARNESS CLAMP BRACKET
Remove the bolt and wire harness clamp bracket from the camshaft housing sub-assembly.
Using an 8 mm socket wrench, remove the 2 bolts and wire harness clamp bracket from the camshaft housing sub-assembly.