|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
G3850
1.INSTALL NO. 1 TRACTION BATTERY DEVICE BOX ASSEMBLY
|
|
G3830A
2.INSTALL ELECTRIC VEHICLE BATTERY PLUG ASSEMBLY
|
|
71033
7.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY
76971G
8.INSTALL REAR UNDER COVER
72693
9.INSTALL REAR SEAT CUSHION LOCK HOOK
10.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY
73350C
11.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
G3834
12.INSTALL SERVICE PLUG GRIP
13. PERFORM CURRENT SENSOR OFFSET LEARNING
|
|
Connect the GTS to the DLC3.
Turn the ignition switch on (READY).
Perform a road test.
Accelerate and decelerate gently. Avoid rapid acceleration and deceleration.
1. Enter the following menus: Powertrain / HV Battery / Data List / Hybrid Battery Current.
| Tester Display |
|---|
| Hybrid/EV Battery Current |
2. Drive the vehicle with the value of Data List item "Hybrid Battery Current" between -50 A and 50 A.
Distance and driving time are not specified.
3. Turn the ignition switch off and leave the vehicle for 30 seconds or more.
4. Turn the ignition switch on (IG).
5. Enter the following menus: Powertrain / HV Battery / Data List / Hybrid Battery Current.
| Tester Display |
|---|
| Hybrid/EV Battery Current |
4. Check that the value of "Hybrid Battery Current" is between -0.5 A and 0.5 A with the ignition switch on (IG).
If the value is outside the specified range, perform the road test again.
When the ignition switch is on (IG), if value of "Hybrid Battery Current" is between -0.5 A and 0.5 A, current sensor offset learning has been completed.
Even if the current sensor offset learning is not complete, the current sensor value will be corrected by repeating the road test a maximum of 7 times.