|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
1.INSTALL CAMBER ADJUST CAM SUB-ASSEMBLY
48452R
2.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION TOE ADJUST PLATE
| *a | Matchmark | - | - |
Align the matchmarks on the camber adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.
Temporarily install the lower control arm assembly to the rear suspension member sub-assembly with the camber adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and nut.
48730
3.TEMPORARILY TIGHTEN LOWER CONTROL ARM ASSEMBLY
Temporarily install the lower control arm assembly to the rear No. 1 suspension arm assembly with the bolt and nut.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
4.INSTALL REAR WHEEL
5. STABILIZE SUSPENSION
48730
6.FULLY TIGHTEN LOWER CONTROL ARM ASSEMBLY
Install the rear upper control arm assembly with the bolt and nut.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Fully tighten the nut.
Hold the suspension camber adjust cam sub-assembly while rotating the nut.
7.INSPECT AND ADJUST REAR WHEEL ALIGNMENT