| *1 | REAR NO. 1 SUSPENSION ARM ASSEMBLY | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48070
1.INSTALL REAR SUSPENSION ARM BRACKET ASSEMBLY
Install the rear suspension arm bracket assembly to the vehicle with the 4 bolts.
Temporarily tighten the bolt (A), and then fully tighten the 4 bolts and nut in the order of (B), (A), (C) and (D).
2.INSTALL TOE ADJUST CAM SUB-ASSEMBLY
48452R
3.TEMPORARILY TIGHTEN REAR NO. 2 SUSPENSION TOE ADJUST PLATE
| *a | Matchmark | - | - |
Align the matchmarks on the toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and rear suspension member sub-assembly.
Temporarily install the rear No. 1 suspension arm assembly to the rear suspension arm bracket assembly with the toe adjust cam sub-assembly, rear No. 2 suspension toe adjust plate and nut.
Fully tighten the rear No. 2 suspension toe adjust plate after adjust rear wheel alignment.
48258C
4.INSTALL REAR LOWER COIL SPRING INSULATOR
5.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
48452R
6.FULLY TIGHTEN REAR NO. 2 SUSPENSION TOE ADJUST PLATE
Fully tighten the nut.
Hold the toe adjust cam sub-assembly while rotating the nut.