| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 7 | NO. 2 PARKING BRAKE WIRE ASSEMBLY | 890C0A | - | - | - |
| 8 | NO. 1 PARKING BRAKE WIRE ASSEMBLY | 890C0 | - | - | - |
| 9 | REAR AXLE HUB AND BEARING ASSEMBLY | 42450B | - | - | - |
| *A | for LH Side | *B | for RH Side |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
| *1 | CAMBER ADJUST CAM SUB-ASSEMBLY | *2 | REAR NO. 2 SUSPENSION TOE ADJUST PLATE |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | - | - |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48258C
1.INSTALL REAR LOWER COIL SPRING INSULATOR
Install the rear lower coil spring insulator to the rear No. 1 suspension arm assembly.
Securely insert the protrusion of the rear lower coil spring insulator into the guide holes of the rear No. 1 suspension arm assembly.
48259A
2.INSTALL REAR UPPER COIL SPRING INSULATOR
| *a | Fit | - | - |
Install the rear upper coil spring insulator to the rear coil spring.
Install the rear upper coil spring insulator so that the dimension between the stopper and upper end of the rear coil spring is 10 mm (0.394 in.) or less.
48231B
3.INSTALL REAR COIL SPRING
Set the rear coil spring to the rear No. 1 suspension arm assembly.
Make sure that there is no gap between the coil end of the rear coil spring and the stopper of the rear lower coil spring insulator.
48540
4.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
48730
5.INSTALL LOWER CONTROL ARM ASSEMBLY
48790
6.INSTALL REAR UPPER CONTROL ARM ASSEMBLY
890C0A
7.INSTALL NO. 2 PARKING BRAKE WIRE ASSEMBLY (for LH Side)
890C0
8.INSTALL NO. 1 PARKING BRAKE WIRE ASSEMBLY (for RH Side)
10. STABILIZE SUSPENSION
48540
11.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
14.INSPECT AND ADJUST REAR WHEEL ALIGNMENT
15.PERFORM INITIALIZATION
16. CHECK FOR SPEED SENSOR SIGNAL