The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the rear axle beam assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE REAR WHEEL
42450B
2.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
42450A
3.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY RH
Perform the same procedure as for the LH side.
48258C
4.REMOVE REAR LOWER COIL SPRING INSULATOR LH
48258B
5.REMOVE REAR LOWER COIL SPRING INSULATOR RH
Perform the same procedure as for the LH side.
6.SEPARATE REAR SHOCK ABSORBER
|
|
Support the rear axle beam assembly with an engine lifter using 2 wooden blocks and 2 attachments or equivalent tools as shown in the illustration.
Remove the 2 bolts and 2 nuts while holding the 2 nuts and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Because the nuts have their own stoppers, do not turn the nuts. Loosen the bolts with the nuts secured.
42110F
7.REMOVE REAR AXLE BEAM ASSEMBLY
Remove the 2 bolts and rear axle beam assembly.