Home › General › MAINTENANCE › FRONT BRAKE FLEXIBLE HOSE
RM3700E _V1 General _093024 MAINTENANCE _0441901 FRONT BRAKE FLEXIBLE HOSE A

MAINTENANCE  FRONT BRAKE FLEXIBLE HOSE  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C445657N01
6.313,0.24 6.76,0.24 false 6.438,0.635 6.771,0.635 false 5.656,3.083 5.99,3.083 false 5.698,0.115 6.24,0.406 0.542,0.292 18 false , 2 6.031,2.948 6.229,3.198 0.198,0.25 18 false 3 6.229,0.5 6.427,0.75 0.198,0.25 18 false 4 5.24,0.104 5.781,0.396 0.542,0.292 18 false 1 5.979,0.177 6.354,0.385 0.375,0.208 12 false (*A) 5.385,0.167 5.76,0.375 0.375,0.208 12 false (*A)

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 BRAKE CONTROL - (Click here) - -
3 FRONT WHEEL - - - -
4 BRAKE FLUID - - (Click here) -

*A for HV Model - -

C445658N01
1.917,1.583 2.083,1.583 2.083,1.583 2.854,2.385 true 3.896,5.417 4.229,5.417 true 6.063,1.938 6.396,1.938 true 1.708,5.219 2.042,5.219 true 3.031,0.542 3.365,0.542 true 1.781,0.906 1.948,0.906 1.948,0.906 2.948,1.948 true 1.427,1.438 1.896,1.719 0.469,0.281 18 true 5, 6 1.583,0.833 1.76,1.083 0.177,0.25 10 true *1 4.313,5.365 4.469,5.563 0.156,0.198 10 false ● 6.458,1.875 6.615,2.073 0.156,0.198 10 false ● 1.531,5.167 1.688,5.365 0.156,0.198 10 false ● 2.802,0.479 2.979,0.729 0.177,0.25 10 true *2

Procedure Part Name Code
Z101186

Z101188

Z101187

5 DISCONNECT FRONT FLEXIBLE HOSE 47313J - - -
6 REMOVE FRONT FLEXIBLE HOSE 47313J - - -

*1 FRONT SPEED SENSOR *2 BRAKE LINE
● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front brake flexible hose removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced (for HV Model)
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (Click here)

NOTICE:

If both left and right front flexible hoses are disconnected at the same time, be sure to place an identification mark on each hose to indicate its installation position.


HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used. (for HV Model)

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1. PRECAUTION (for HV Model)

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISABLE BRAKE CONTROL (for HV Model)

Z101186

Click here(Click here)

Hide 3.REMOVE FRONT WHEEL

Hide 4.DRAIN BRAKE FLUID

Z101186

NOTICE:

If brake fluid leaks onto any painted surface, immediately wash it off.



Hide 47313J 5.DISCONNECT FRONT FLEXIBLE HOSE

Hide 47313J 6.REMOVE FRONT FLEXIBLE HOSE

a.
C445659N01
0.427,0.01 0.708,0.365 0.281,0.354 18 false i 3.917,0.083 4.458,0.427 0.542,0.344 18 true ii, iii

i.

Remove the bolt and separate the front flexible hose from the front shock absorber assembly.


ii.

Using a union nut wrench, disconnect the brake line while holding the front flexible hose with a wrench.

NOTICE:
·

Do not kink or damage the brake line.

·

Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting parts.




iii.

Remove the clip and front flexible hose from the vehicle body.