| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | CENTER NO. 4 ENGINE UNDER COVER | 51447D | - | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
51447D
1.REMOVE CENTER NO. 4 ENGINE UNDER COVER
17410
2.REMOVE FRONT EXHAUST PIPE ASSEMBLY
|
|
58151
3.REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR
|
|
89467B
4.REMOVE AIR FUEL RATIO SENSOR
17167
5.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
|
|
17118
6.REMOVE MANIFOLD STAY
|
|
17141
7.REMOVE EXHAUST MANIFOLD
|
|
17173
8.REMOVE EXHAUST MANIFOLD TO HEAD GASKET
17168
9.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR