|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
16031
1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Install a new gasket to the water inlet with thermostat sub-assembly.
Be sure to clean the contact surfaces.
Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.
Connect the water inlet with thermostat sub-assembly connector.
16283
2.INSTALL NO. 6WATER BY-PASS HOSE
3.INSTALL BRACKET
Using an 8 mm socket wrench, connect the bracket to the engine water pump assembly (water inlet housing) with the bolt.
Connect the engine water pump assembly (water inlet housing) connector.
16572D
4.CONNECT NO. 2 RADIATOR HOSE
27020
5.INSTALL GENERATOR WITH REGULATOR ASSEMBLY
for 80A Type:
Click herePower Source / Network>M15A-FKS (BATTERY / CHARGING)>GENERATOR (for 80A Type)>INSTALLATION
for 100A Type:
Click herePower Source / Network>M15A-FKS (BATTERY / CHARGING)>GENERATOR (for 100A Type)>INSTALLATION
17111
6.INSTALL INTAKE MANIFOLD
7.ADD ENGINE COOLANT
8.INSPECT FOR COOLANT LEAK
51410
9.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY