| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.
When disassembling the brake pedal support assembly, do not loosen the breakaway bolt at the time of collisions.
If the breakaway bolt at the time of collisions is loosened, replace with a new brake pedal support assembly.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
1.REMOVE STEERING COLUMN ASSEMBLY
84340
2.REMOVE STOP LIGHT SWITCH ASSEMBLY
47101A
4.REMOVE BRAKE PEDAL RETURN SPRING
47264A
5.REMOVE PUSH ROD PIN
6.SEPARATE ENGINE ROOM MAIN WIRE
47110
7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY
47121
8.REMOVE BRAKE PEDAL PAD