|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
29300
1.INSTALL VACUUM PUMP ASSEMBLY
| *a | Coupling Teeth | *b | Groove |
When reusing the vacuum pump assembly:
Install a new No. 1 vacuum pump O-ring to the vacuum pump assembly.
Install the vacuum pump assembly so that the coupling teeth of the vacuum pump assembly and groove of the camshaft are engaged.
Ensure that the vacuum pump assembly is installed securely.
Be careful not to pinch the No. 1 vacuum pump O-ring.
Using an 8 mm socket wrench, install the vacuum pump assembly with the 3 bolts.
After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.
82121
2.INSTALL ENGINE WIRE
77261D
3.INSTALL FUEL TANK TO CANISTER TUBE
44777
4.CONNECT NO. 1 VACUUM HOSE CONNECTOR
|
|
Align the No. 1 vacuum hose connector with the vacuum pump assembly, and push them together until the No. 1 vacuum hose connector makes a "click" sound.
89661
5.INSTALL ECM
6.INSPECT VACUUM PUMP OPERATION