| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | NO. 1 ENGINE UNDER COVER ASSEMBLY | 51451A | - | - | - |
| 2 | DRAIN ENGINE OIL | - | - | ( )
|
- |
| 3 | OIL PAN SUB-ASSEMBLY | 12101 | ( )
|
- | - |
| 4 | ENGINE OIL LEVEL SENSOR | 89491 | ( )
|
- | - |
| *A | Full Cover Type | - | - |
| ● | Non-reusable part | - | - |
This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
51410
1.REMOVE NO. 1 ENGINE UNDER COVER ASSEMBLY
2.DRAIN ENGINE OIL
89491
4.REMOVE ENGINE OIL LEVEL SENSOR
Disconnect the engine oil level sensor connector.
Remove the clip from the engine oil level sensor.
Using an 8 mm socket wrench, remove the 2 bolts and engine oil level sensor from the engine balancer assembly.