| *A | for Gasoline Model | *B | for HV Model: |
| *C | for LH Side | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 11 | CENTER PILLAR UPPER GARNISH | 62411B | - | - | - |
| 12 | FRONT SEAT OUTER BELT ASSEMBLY | 73210 | ( )
|
- | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat outer belt assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the RH side and LH side.
The procedure listed below is for the RH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
76973F
3.REMOVE REAR UNDER SIDE COVER (for HV Model LH Side)
67917F
4.REMOVE REAR DOOR INSIDE SCUFF PLATE
62331A
5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
67913B
6.REMOVE FRONT DOOR SCUFF PLATE
62311B
7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
73233
8.REMOVE LAP BELT OUTER ANCHOR COVER
73210
9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY
62413A
10.REMOVE CENTER PILLAR LOWER GARNISH
62411B
11.REMOVE CENTER PILLAR UPPER GARNISH
73210
12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY
| *A | w/ Smart Entry and Start System | *B | w/o Smart Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Remove the bolt to disconnect the shoulder anchor of the front seat outer belt assembly.
Disconnect the pretensioner connector.
Refer to How to Connector or Disconnect Airbag Connector:
Remove the 2 bolts.
Disengage the guides to remove the front seat outer belt assembly.