The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition.
The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication.
If there is a malfunction in the bus lines between the yaw rate and acceleration sensor (airbag sensor assembly) and the CAN communication system, DTCs U012587 are output. When DTCs U012587 are output together with C051D54 and/or C121054, inspect and repair the trouble areas indicated by U012587 first.
These DTCs are also output when the calibration has not been completed.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C051D54 | Multi-axis Acceleration Sensor Module "A" Missing Calibration | Zero point calibration of acceleration sensor undone. | ·
Acceleration sensor zero point not calibrated ·
Acceleration sensor (airbag sensor assembly) installation ·
Acceleration sensor (airbag sensor assembly) ·
Skid control ECU (brake actuator assembly) |
Brake/EPB | A |
| C121054 | Yaw Rate Sensor Missing Calibration | Zero point calibration of yaw rate sensor undone. | Yaw rate sensor zero point not calibrated | Brake/EPB | A |
After replacing the skid control ECU (brake actuator assembly), perform "Calibration".
Check if CAN communication system DTCs are output.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (for Gasoline Model)>DIAGNOSIS SYSTEM
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Operate the GTS to perform "Calibration".
| Tester Display |
|---|
| Calibration |
| Proceed to |
|---|
| NEXT |
NEXT
Pre-procedure1
None
Procedure1
Operate the GTS to clear the codes.
| Proceed to |
|---|
| NEXT |
Post-procedure1
Turn the ignition switch off.
NEXT
Operate the GTS to read the DTCs.
| Result | Proceed to |
|---|---|
| C051D54 and C121054 are not output | A |
| C051D54 or C121054 is output | B |
A
B
Pre-procedure1
Turn the ignition switch off.
Procedure1
Check that the yaw rate and acceleration sensor (airbag sensor assembly) has been installed properly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
The yaw rate and acceleration sensor (airbag sensor assembly) is tightened to the specified torque.
The yaw rate and acceleration sensor (airbag sensor assembly) is not installed in a tilted position.
| Proceed to |
|---|
| OK |
| NG |
Post-procedure1
None
OK
NG
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>CENTER AIRBAG SENSOR ASSEMBLY>INSTALLATION
Check the yaw rate and acceleration sensor (airbag sensor assembly) output value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Yaw Rate Sensor Value | Yaw rate sensor | Min.: -128°/s
Max.: 127°/s |
Vehicle stopped: 0°/s
Turning right: -128 to 0°/s Turning left: 0 to 127°/s |
- |
| Tester Display |
|---|
| Yaw Rate Sensor Value |
The yaw rate sensor value is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the yaw rate and acceleration sensor (airbag sensor assembly) output value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Lateral G | Lateral G | Min.: -25.105 m/s2
Max.: 24.908 m/s2 |
Turning right: -25.105 to 0.000 m/s2
Turning left: 0.000 to 24.908 m/s2 |
During turning:
Changes in proportion with lateral acceleration |
| Tester Display |
|---|
| Lateral G |
The lateral G value is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Check the yaw rate and acceleration sensor (airbag sensor assembly) output value displayed on the GTS.
| Tester Display | Measurement Item | Range | Normal Condition | Diagnostic Note |
|---|---|---|---|---|
| Forward and Rearward G | Forward and Rearward G | Min.: -25.105 m/s2
Max.: 24.908 m/s2 |
During deceleration:-25.105 to 0.000 m/s2
During acceleration: 0.000 to 24.908 m/s2 |
During acceleration/deceleration:
Changes in proportion with acceleration |
| Tester Display |
|---|
| Forward and Rearward G |
The forward and rearward G value is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG