Refer to DTC C050C1F.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from | Priority |
|---|---|---|---|---|---|
| C050C3A | Left Rear Wheel Speed Sensor Signal Has Too Many Pulses | When not in Dealer Mode (Signal Check) or Inspection Mode, the output of the speed sensor detected by the skid control ECU (brake booster with master cylinder assembly) is too high for 5 second or more. | ·
Rear speed sensor LH*1 ·
Rear speed sensor LH (rear axle hub and bearing assembly LH)*2 |
Brake/EPB | A |
*1: for AWD
*2: for 2WD
After replacing or removing and installing a speed sensor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
After replacing or removing and installing a speed sensor rotor, perform Dealer Mode (Signal Check) inspection to confirm that the speed sensors are operating correctly.
Check the vehicle specification.
| Result | Proceed to |
|---|---|
| for AWD | A |
| for 2WD | B |
A
B
| Proceed to |
|---|
| NEXT |
NEXT
Click hereDrivetrain>AXLE AND DIFFERENTIAL>REAR AXLE HUB (for 2WD)>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT