Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE SYSTEM (for HV Model TMMF Made) › from 2021.07
RM3700E _54 Brake _093767 BRAKE SYSTEM (OTHER) _0480835 BRAKE SYSTEM(for HV Model TMMF Made) G

BRAKE SYSTEM (OTHER)  BRAKE SYSTEM(for HV Model TMMF Made)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:

DTCs may be stored during the inspection procedure. Be sure to clear the DTCs and check that no DTCs are output after the inspection is finished.


PROCEDURE

Hide 47210L 1.INSPECT BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY

a.
C460894C01
2.552,0.281 2.76,0.281 false 1.177,0.271 1.385,0.271 false 0.542,3.406 0.813,3.24 false 2.802,0.177 3.115,0.375 0.313,0.198 10 false *a 1.417,0.167 1.729,0.365 0.313,0.198 10 false *b 0.385,3.365 0.615,3.563 0.229,0.198 10 false *c
*a Pedal Effort Gauge
*b SST (LSPV Gauge)
*c SST (No. 2 Nipple)


Remove the front disc brake cylinder bleeder plug and set a pedal effort gauge and SST.

SST
09709-29018  (09709-00080)


b.

Bleed air from SST (LSPV gauge).

HINT:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>BLEEDING



c.

Shift lever in P and the parking brake applied.


d.

Turn the ignition switch ON (READY), check the hydraulic pressure by depressing the brake pedal.

Standard Result:
Pedal Effort Hydraulic Pressure
50 N (5 kgf, 11.2 lbf) 2.4 MPa (24.5 kgf/cm2, 348 psi)
100 N (10 kgf, 22.5 lbf) 5.4 MPa (55.1 kgf/cm2, 783 psi)
150 N (15 kgf, 33.7 lbf) 8.2 MPa (83.6 kgf/cm2, 1189 psi)
200 N (20 kgf, 45.0 lbf) 11 MPa (112 kgf/cm2, 1595 psi)



e.

Remove the pedal effort gauge and SST, and bleed the brake line.

HINT:

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>BLEEDING



f.

If the result is not as specified, replace the brake booster with master cylinder.

HINT: