| *1 | ENGINE ROOM MAIN WIRE | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Lithium soap base glycol grease | - | - |
47121
1.INSTALL BRAKE PEDAL PAD
47110
2.INSTALL BRAKE PEDAL SUPPORT ASSEMBLY
Engage the 3 clamps to install the wire harness to the brake pedal support assembly.
Temporarily install the brake pedal support assembly with the 2 bolts and 2 nuts.
Tighten the 2 nuts and 2 bolts in the order shown in the illustration.
Install 2 new clips.
Engage the clamp to install the wire harness to the brake pedal support assembly.
47264A
3.INSTALL PUSH ROD PIN
|
Lithium soap base glycol grease | - | - |
Apply lithium soap base glycol grease to the push rod pin and installation hole of the brake pedal support assembly.
Connect the brake master cylinder push rod clevis to the brake pedal support assembly with the push rod pin, and install a new clip.
Be sure to install the push rod pin in the correct direction.
47101A
4.INSTALL BRAKE PEDAL RETURN SPRING
Install the brake pedal return spring to the brake pedal support assembly as shown in the illustration.
84345
5.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER
7.INSTALL STEERING COLUMN ASSEMBLY
8.INSPECT AND ADJUST BRAKE PEDAL