Home › Brake › BRAKE SYSTEM (OTHER) › BRAKE PEDAL (for Gasoline Model RHD) › from 2021.07
RM3700E _54 Brake _093767 BRAKE SYSTEM (OTHER) _0480842 BRAKE PEDAL(for Gasoline Model RHD) A

BRAKE SYSTEM (OTHER)  BRAKE PEDAL(for Gasoline Model RHD)  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
C442454N02
4.833,1.646 5.167,1.646 false 3.969,0.99 4.302,0.99 false 3.792,1.417 4.125,1.417 false 0.615,3.969 0.948,3.969 false 3.823,3.448 4.156,3.448 false 4.563,4.875 4.896,4.875 false 1.427,3.917 1.427,4.25 false 1.781,2.625 2.115,2.625 false 1.802,1.313 1.802,0.979 false 2.229,4.656 2.229,4.99 false 5.229,1.531 5.51,1.885 0.281,0.354 18 false 1 4.365,0.865 4.646,1.219 0.281,0.354 18 false 2 4.521,1.26 4.802,1.615 0.281,0.354 18 false 3 1.729,1.323 2.01,1.677 0.281,0.354 18 false 6 1.583,2.5 1.865,2.854 0.281,0.354 18 false 7 0.427,3.844 0.708,4.198 0.281,0.354 18 false 4 4.219,3.323 4.5,3.677 0.281,0.354 18 false 5 4.948,4.75 5.229,5.104 0.281,0.354 18 false 8 1.385,4.25 1.667,4.604 0.281,0.354 10 false ● 4.375,1.313 4.594,1.51 0.219,0.198 10 false ● 2.188,5 2.469,5.354 0.281,0.354 10 false ● 2.26,4.646 2.583,4.844 0.323,0.198 10 false x2 3.229,4.01 3.552,4.208 0.323,0.198 10 false x2 2.073,2.854 2.396,3.052 0.323,0.198 10 false x2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 STEERING COLUMN ASSEMBLY - - - -
2 STOP LIGHT SWITCH ASSEMBLY 84340 - - -
3 STOP LIGHT SWITCH MOUNTING ADJUSTER 84345 (Click here) - -
4 BRAKE PEDAL RETURN SPRING 47101A - - -
5 PUSH ROD PIN 47264A - - -
6 ENGINE ROOM MAIN WIRE - - - -
7 BRAKE PEDAL SUPPORT ASSEMBLY 47110 - - -
8 BRAKE PEDAL PAD 47121 - - -

● Non-reusable part - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during brake pedal support assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

NOTICE:
·

When disassembling the brake pedal support assembly, do not loosen the breakaway bolt at the time of collisions.

·

If the breakaway bolt at the time of collisions is loosened, replace with a new brake pedal support assembly.



HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1.REMOVE STEERING COLUMN ASSEMBLY

Hide 84340 2.REMOVE STOP LIGHT SWITCH ASSEMBLY

Hide 84345 3.REMOVE STOP LIGHT SWITCH MOUNTING ADJUSTER

Z101186

Click here(Click here)

Hide 47101A 4.REMOVE BRAKE PEDAL RETURN SPRING

a.
C429813


Hide 47264A 5.REMOVE PUSH ROD PIN

a.
C429815


Hide 6.SEPARATE ENGINE ROOM MAIN WIRE

a.
C429817


Hide 47110 7.REMOVE BRAKE PEDAL SUPPORT ASSEMBLY

a.
C429821


Hide 47121 8.REMOVE BRAKE PEDAL PAD

a.
C430392