| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 1 | BRAKE MASTER CYLINDER O-RING | - | - | - | - |
| 2 | BRAKE MASTER CYLINDER SUB-ASSEMBLY | 47201 | ( )
|
- | - |
| 3 | CONNECT BRAKE LINE | - | ( )
|
- | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | * | For use with a union nut wrench |
| ● | Non-reusable part | - | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
1.INSTALL BRAKE MASTER CYLINDER O-RING
47201
2.INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY
|
|
Install the brake master cylinder sub-assembly to the brake booster assembly with 2 new nuts.
The brake master cylinder sub-assembly requires careful handling. Do not drop or subject the brake master cylinder sub-assembly to any impact. Do not reuse a brake master cylinder sub-assembly that has been dropped.
Do not hold the brake master cylinder sub-assembly by the master cylinder piston. Hold the brake master cylinder sub-assembly by its body or its reservoir when carrying it.
Do not pull out the master cylinder piston.
Do not strike or pinch the master cylinder piston, or cause any damage to the master cylinder piston by any other means.
When installing the brake master cylinder sub-assembly to the brake booster assembly, or when removing the brake master cylinder sub-assembly from the brake booster assembly, make sure that the brake master cylinder sub-assembly is kept horizontal or with its tip facing downward (the master cylinder piston is facing upward) to prevent the master cylinder piston from falling out.
Do not allow any foreign matter to contaminate the master cylinder piston. If any foreign matter gets on the master cylinder piston, remove it by using a piece of new and dry cloth. Do not use water or detergent. Then apply an even layer of lithium soap base glycol grease around the circumference (sliding part) of the master cylinder piston.
Do not use any other types of grease.
Do not kink or damage the brake lines.
Do not allow the brake lines to twist or interfere with other parts or the vehicle body during tightening.
Do not allow any foreign matter such as dirt or dust to enter the brake lines from the connecting parts.
Engage the clamp to the brake master cylinder sub-assembly.
Connect the connector to the brake master cylinder reservoir assembly.
3.CONNECT BRAKE LINE
|
|
| *a | Torque Wrench Fulcrum Length | - | - |
Using a union nut wrench, connect the 2 brake lines to the brake master cylinder sub-assembly.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a union nut wrench (fulcrum length of 20 mm (0.787 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.)):
17.4 N*m (177 kgf*cm, 13 ft.*lbf)
4.BLEED BRAKE LINE
55701J
5.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY
55734A
6.INSTALL WATER GUARD PLATE RH
55815E
7.INSTALL FRONT NO. 1 VENTILATOR SEAL
8.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY