|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
48069
1.TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Temporarily install the front lower No. 1 suspension arm sub-assembly to the front suspension crossmember sub-assembly with the 2 bolts and nut.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Connect the front lower No. 1 suspension arm sub-assembly to the front lower ball joint assembly with the bolt and 2 nuts.
2.INSTALL FRONT WHEEL
48069
4.FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY
Fully tighten the bolt (A).
Fully tighten the bolt (B).
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
51410
5.INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY
6.INSPECT AND ADJUST FRONT WHEEL ALIGNMENT