| *1 | FRONT DISC BRAKE CYLINDER SLIDE BUSHING | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
|
Lithium soap base glycol grease | - | - |
| *1 | FRONT BRAKE PAD RADIAL SPRING | - | - |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) | ● | Non-reusable part |
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
After replacing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.
After replacing the front disc brake pads, always perform a road test to check the braking performance and check for vibrations.
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
43512
1.INSTALL FRONT DISC
|
|
| *a | Matchmark | - | - |
Align the matchmarks of the front disc and front axle hub sub-assembly, and install the front disc.
47722
2.INSTALL FRONT DISC BRAKE CYLINDER MOUNTING
3.INSTALL FRONT DISC BRAKE BUSHING DUST BOOT
|
Lithium Soap Base Glycol Grease | - | - |
Apply a light layer of lithium soap base glycol grease to the entire circumference of 2 new front disc brake bushing dust boots.
Apply more than 0.3 g (0.01 oz) of lithium soap base glycol grease to each front disc brake bushing dust boot.
Install the 2 front disc brake bushing dust boots to the front disc brake cylinder mounting.
47715A
4.INSTALL FRONT DISC BRAKE CYLINDER SLIDE PIN
|
Lithium Soap Base Glycol Grease | - | - |
Apply a light layer of lithium soap base glycol grease to the contact surface of the front disc brake cylinder slide pin (lower side).
Install a new front disc brake cylinder slide bushing to the front disc brake cylinder slide pin (lower side).
Apply a light layer of lithium soap base glycol grease to the sliding part and the sealing surfaces of the 2 front disc brake cylinder slide pins.
Install the 2 front disc brake cylinder slide pins to the front disc brake cylinder mounting.
Push each front disc brake cylinder slide pin into the front disc brake bushing dust boot to engage the pin to the boot.
5.INSTALL FRONT DISC BRAKE PAD SUPPORT PLATE
|
|
8.INSTALL FRONT DISC BRAKE PAD
|
|
47750
9.INSTALL FRONT DISC BRAKE CYLINDER ASSEMBLY
|
|
47313J
10.CONNECT FRONT FLEXIBLE HOSE
|
|
11.BLEED BRAKE LINE
for HV Model TMMF Made:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for HV Model TMMF Made)>BLEEDING
for Gasoline Model:
Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE FLUID (for Gasoline Model)>BLEEDING
12.INSTALL FRONT WHEEL