Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER › from 2021.07
RM3700E _58 Vehicle Interior _093020 HEATING / AIR CONDITIONING _0438505 AIR CONDITIONING AMPLIFIER A

HEATING / AIR CONDITIONING  AIR CONDITIONING AMPLIFIER  REMOVAL  


CAUTION / NOTICE / HINT

COMPONENTS (REMOVAL)
I117560N01
0.708,1.979 2.594,3.521 1.885,1.542 1.25,2.677 1.604,2.677 false 6.521,0.219 6.875,0.219 false 6.479,0.646 6.833,0.646 false 5.646,3.354 5.646,3.021 false 3.646,3.302 3.646,2.969 false 6.479,3.167 6.792,3.365 0.313,0.198 10 false x2 5.594,3.406 5.906,3.802 0.313,0.396 18 false 3 1.052,2.531 1.365,2.927 0.313,0.396 18 false 4 6.354,0.073 6.667,0.469 0.313,0.396 18 false 1 6.313,0.49 6.625,0.885 0.313,0.396 18 false 2 0.792,2.052 1.167,2.292 0.375,0.24 12 false *A 3.573,3.333 3.885,3.729 0.313,0.396 18 false 5 2.354,2.49 2.667,2.688 0.313,0.198 10 false x3

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - - - -
3 NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY 55606 - - -
4 ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY 78110K (Click here) - -
5 AIR CONDITIONING AMPLIFIER ASSEMBLY 88650N - - -

*A for LHD - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during the air conditioning amplifier assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)
Air conditioning amplifier assembly
w/ Stop and Start System:
1.

Reset air conditioning information

2.

Learning of air conditioning information


Engine start function (Click here)
Initialize servo motor (Air Conditioning System) DTCs are stored for Gasoline Model:(Click here)
for HV Model:(Click here)

HINT:
·

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system *1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for LHD and RHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

Z101186

NOTICE:

After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 78110K 4.REMOVE ACCELERATOR PEDAL(W/SENSOR) ROD ASSEMBLY (for LHD)

Z101186

·

for Gasoline Model:

(Click here)

·

for HV Model:

(Click here)



Hide 88650N 5.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

a.
I117561C01
0.844,3.969 1.219,4.208 0.375,0.24 12 false *A 4.188,4.021 4.563,4.26 0.375,0.24 12 false *B
*A for Automatic Air Conditioning System *B for Manual Air Conditioning System