| *A | for 2WD | *B | for AWD |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part | - | - |
| Procedure | Part Name Code |
|
|
|
|
|---|---|---|---|---|---|
| 14 | FRONT EXHAUST PIPE ASSEMBLY | 17410 | ( )
|
- | - |
| 15 | NO.1 CENTER FLOOR BRACE | 57543C | - | - | - |
| 16 | CENTER NO. 4 ENGINE UNDER COVER | 51447D | - | - | - |
| *A | for 2WD | *B | for AWD |
| *C | for TMMF Made | *D | for TMC Made |
|
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
77277R
1.INSTALL FUEL TANK FILLER PIPE PROTECTOR
77218A
2.INSTALL NO. 3 FUEL TANK FILLER PIPE SUPPORT
77216A
3.INSTALL NO. 1 FUEL TANK FILLER PIPE SUPPORT
77217C
4.INSTALL NO. 2 FUEL TANK FILLER PIPE SUPPORT
77027B
5.INSTALL NO. 1 FUEL EMISSION TUBE SUB-ASSEMBLY
77209F
6.INSTALL FUEL TANK MAIN TUBE SUB-ASSEMBLY
77100U
7.INSTALL FUEL TANK ASSEMBLY
|
|
Set the fuel tank assembly on an engine lifter.
Using height adjustment attachments and plate lift attachments, keep the fuel tank assembly horizontal.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with the 4 bolts.
Using the engine lifter, slowly raise the fuel tank assembly, and then temporarily install the fuel tank assembly with the 4 bolts.
Tighten the 4 bolts in the order shown in the illustration.
Be careful not to drop the fuel tank assembly.
When installing the fuel tank assembly, tilt it slightly to prevent it from interfering with the surrounding parts.
8.INSTALL FUEL TANK FILLER PIPE SUB-ASSEMBLY
77730C
9.CONNECT NO. 2 CHARCOAL CANISTER ASSEMBLY
77209F
10.CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY
Connect the fuel tank main tube sub-assembly to the fuel pipe.
Click hereEngine / Hybrid System>M15A-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77027B
11.CONNECT NO. 1 FUEL EMISSION TUBE SUB-ASSEMBLY
Connect the No. 1 fuel emission tube sub-assembly to the fuel pipe and slide the clip to secure it.
Click hereEngine / Hybrid System>M15A-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
77606
12.INSTALL NO. 1 FUEL TANK PROTECTOR SUB-ASSEMBLY
58415Q
13.INSTALL NO. 1 REAR FLOOR BOARD (for 2WD)
57543C
15.INSTALL CENTER NO. 1 FLOOR BRACE (for TMMF Made)
51447D
16.INSTALL CENTER NO. 4 ENGINE UNDER COVER
77310A
17.INSTALL FUEL TANK CAP ASSEMBLY
77020A
18.INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
65638
19.INSTALL REAR WHEEL HOUSE LINER LH
52592
20.INSTALL REAR BUMPER SIDE SEAL LH
21.INSTALL WHEEL ASSEMBLY
22.ADD FUEL