| *1 | ROOF SIDE INNER GARNISH CLIP | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the curtain shield airbag assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
63310
3.REMOVE ROOF HEADLINING ASSEMBLY
62170A
4.REMOVE CURTAIN SHIELD AIR BAG ASSEMBLY
|
|
| *A | w/ Entry and Start System | *B | w/o Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector:
| *1 | Roof Side Inner Garnish Clip | - | - |
| *a | Claw (A) | *b | Claw (B) |
|
Remove in this Direction | - | - |
Using needle-nose pliers, remove the pins from the clips.
Using 2 screwdrivers, disengage the claws (A) of each clip and separate the clips from the vehicle body as shown in the illustration.
Separate the clips and curtain shield airbag assembly from the vehicle body as a unit.
Remove the 4 bolts.
While holding the curtain shield airbag assembly, disengage the hooks and the claws (B), and remove the curtain shield airbag assembly.
Remove the roof side inner garnish clips from the curtain shield airbag assembly.