| *A | for Driver Side | *B | for Front Passenger Side |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the side airbag pressure sensor removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
Use the same procedure for the LH and RH sides.
The procedure listed below is for the LH side.
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
|
|
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)
67655
6.REMOVE FRONT DOOR TRIM GARNISH
67601
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68171B
8.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67831
9.REMOVE FRONT DOOR SERVICE HOLE COVER
8983A
10.REMOVE SIDE AIRBAG PRESSURE SENSOR
| *A | w/ Entry and Start System | *B | w/o Entry and Start System |
| *a | Illumination off | - | - |
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Remove the nut.
Do not reuse the nut.
Disengage the claw to pull out the side airbag pressure sensor.
If the side airbag pressure sensor has been dropped, replace it with a new one.
Disconnect the airbag connector.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: