Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY › from 2021.07
RM3700E _58 Vehicle Interior _092991 SEAT BELT _0443757 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

B618039N01
0.094,3.833 3.51,5.667 3.417,1.833 0.385,4.26 1.885,5.51 1.5,1.25 1.396,2.5 3.271,3.375 1.875,0.875 4.906,1.656 5.24,1.656 false 2.865,1.344 3.198,1.344 false 4.177,2.208 4.51,2.208 false 2.396,5.01 2.396,5.344 false 0.708,5.135 1.042,5.135 false 3.802,5.021 3.802,5.354 false 6.542,0.198 6.875,0.198 false 6.5,0.667 6.833,0.667 false 4.844,4.427 4.844,4.76 false 6.125,3.646 6.125,3.979 false 2.031,3.042 2.365,3.042 false 1.448,2.531 1.823,2.771 0.375,0.24 12 false *A 0.188,3.896 0.563,4.135 0.375,0.24 12 false *B 0.458,4.323 0.833,4.563 0.375,0.24 12 false *C 0.531,4.979 0.813,5.333 0.281,0.354 18 false 3 2.323,5.354 2.604,5.708 0.281,0.354 18 false 4 1.833,2.896 2.115,3.25 0.281,0.354 18 false 4 2.677,1.177 2.958,1.531 0.281,0.354 18 false 5 6.094,4.031 6.375,4.385 0.281,0.354 18 false 6 3.74,5.396 4.281,5.729 0.542,0.333 18 false 8 4.792,4.802 5.302,5.156 0.51,0.354 18 false 9 4.594,2.052 5.073,2.417 0.479,0.365 18 false 10 5.302,1.49 5.854,1.865 0.552,0.375 18 false 7 6.333,0.042 6.615,0.396 0.281,0.354 18 false 1 6.313,0.5 6.594,0.854 0.281,0.354 18 false 2

Procedure Part Name Code
Z101186

Z101188

Z101187

1 PRECAUTION - (Click here) - -
2 CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL - (Click here) - -
3 REAR UNDER SIDE COVER 76973F - - -
4 REAR DOOR INSIDE SCUFF PLATE 67917F - - -
5 REAR DOOR OPENING TRIM WEATHERSTRIP 62331A - - -
6 FRONT DOOR SCUFF PLATE 67913B - - -
7 FRONT DOOR OPENING TRIM WEATHERSTRIP 62311B - - -
8 LAP BELT OUTER ANCHOR COVER 73233 - - -
9 FRONT SEAT OUTER BELT ASSEMBLY 73210 - - -
10 CENTER PILLAR LOWER GARNISH 62413A - - -

*A for Gasoline Model *B for HV Model
*C for LH Side - -

B620453N01
3.198,4.542 3.198,4.208 false 1.167,1.698 1.5,1.698 false 1.823,3.104 2.135,3.302 0.313,0.198 10 false x2 0.823,1.542 1.375,1.896 0.552,0.354 18 false 11 3.24,4.573 3.792,4.927 0.552,0.354 18 false 12

Procedure Part Name Code
Z101186

Z101188

Z101187

11 CENTER PILLAR UPPER GARNISH 62411B - - -
12 FRONT SEAT OUTER BELT ASSEMBLY 73210 (Click here) - -

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front seat outer belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Parking assist monitor system (Click here)
Panoramic view monitor system (w/o Advanced Park) (Click here)

HINT:
·

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

-

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link

*1: for Gasoline Model

Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system
Parking support brake system
Stop and start system*1 Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes) (Click here)

-

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Power back door system Fully close the back door by hand.
HINT:

Initialization is not necessary if the above procedures are performed while the back door is closed.


(Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -


·

Use the same procedure for RHD and LHD.

·

The following procedure is for LHD.

·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

Z101186

CAUTION:
B473126

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here(Click here)



Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Z101186

CAUTION:
B422343

·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





Hide 76973F 3.REMOVE REAR UNDER SIDE COVER (for HV Model LH Side)

Hide 67917F 4.REMOVE REAR DOOR INSIDE SCUFF PLATE

Hide 62331A 5.DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

a.
B618041


Hide 67913B 6.REMOVE FRONT DOOR SCUFF PLATE

Hide 62311B 7.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

a.
B618042


Hide 73233 8.REMOVE LAP BELT OUTER ANCHOR COVER

a.
B618043


Hide 73210 9.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.
B618044


Hide 62413A 10.REMOVE CENTER PILLAR LOWER GARNISH

Hide 62411B 11.REMOVE CENTER PILLAR UPPER GARNISH

Hide 73210 12.REMOVE FRONT SEAT OUTER BELT ASSEMBLY

a.
B618045C01
1.354,0.833 0.354,0.833 true 0.135,0.708 0.448,0.865 0.313,0.156 10 false *a 4.615,0.104 4.896,0.458 0.281,0.354 18 false ii 0.167,0.094 0.448,0.448 0.281,0.354 18 false i 1.833,1.771 2.115,2 0.281,0.229 12 true *A 3.021,1.792 3.396,2.031 0.375,0.24 12 false *B
*A w/o Entry and Start System *B w/ Entry and Start System
*a Illumination off - -


i.

Check that the ignition switch is off.


ii.

Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

CAUTION:
·

Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

·

If the airbag deploys for any reason, it may cause a serious accident.





b.
B620222C02
0.167,2 3.333,3.75 3.167,1.75 3.5,0.094 6.698,1.938 3.198,1.844 3.552,0.146 3.917,0.479 0.365,0.333 12 false *A 0.26,2.063 0.708,2.406 0.448,0.344 12 false *B 1.396,0.323 1.531,0.615 0.135,0.292 18 true i 4.552,0.51 4.76,0.813 0.208,0.302 18 true ii 5.542,2.083 5.76,2.385 0.219,0.302 18 true iii 5.677,3.021 5.896,3.323 0.219,0.302 18 true iv 5.677,3.438 5.896,3.74 0.219,0.302 18 true iii 4.885,3.24 5.104,3.542 0.219,0.302 18 true iv 1.479,2.438 1.677,2.771 0.198,0.333 18 true ii
*A for TMMF Made *B for TMC Made


i.

Remove the bolt to disconnect the shoulder anchor of the front seat outer belt assembly.


ii.

Disconnect the pretensioner connector.

HINT:

Refer to How to Connector or Disconnect Airbag Connector:

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR



iii.

Remove the 2 bolts.


iv.

Disengage the guides to remove the front seat outer belt assembly.