| *A | for Driver Side | *B | for Front Passenger Side |
| *A | for Driver Side | *B | w/o Double Locking System |
| *C | w/ Double Locking System | - | - |
| *1 | Hole plug | - | - |
| ● | Non-reusable part | - | - |
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the front door lock assembly removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is driven
Learning completes when vehicle is operated normally
Use the same procedure for the LH side and RH side.
The following procedure is for the RH side.
1. PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
4.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
5.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
67656
6.REMOVE FRONT DOOR TRIM GARNISH
67838A
9.REMOVE FRONT DOOR VENT SEAL
67856B
10.REMOVE FRONT DOOR PANEL PROTECTOR
68142C
13.REMOVE FRONT DOOR GLASS RUN
67404F
14.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
69040A
17.REMOVE FRONT DOOR LOCK WITH MOTOR ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Disconnect the front door lock open rod as shown in the illustration.
Remove the front door lock assembly.
69318C
18.REMOVE DOOR LOCK WIRING HARNESS SEAL
|
When reusing the front door lock assembly:
1. Remove the door lock wiring harness seal from the front door lock assembly. |
69710D
19.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)
|
Remove in this Direction | - | - |
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
69710D
20.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)
Using a screwdriver with its tip wrapped in protective tape, disengage the claws as shown in the illustration.
Disengage the guide to remove the front door lock remote control cable assembly from the front door lock assembly.
69720D
21.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)
69720D
22.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)